[. . . ] It is up to you to prepare a large Phillips head (+) screwdriver for assembly. [. . . ] SP-32 Insert the screws that come with the SP-32 Pedal Unit from the outside of the side panels and temporarily tighten the angle brackets in place. 4 Loosen the screws of the panel brackets at the bottom of the side panels (two screws each panel, four total). 4 Remove the bracket screws from the inside surfaces of the side panels (two screws each panel, four total) and then shift the position of the brackets as shown in the figure. 1-a Replace the screws you removed in step 1-a above and temporarily tighten the brackets in place. Remove the bracket screws from the inside surfaces of the side panels (two screws each panel, four total). Mount the pedal unit onto the angle brackets you installed in step 2 of this procedure. [. . . ] 2 Note that you must install the two clips on the side panel of the stand as shown in the illustration. [. . . ]